Frames & Springer Front Ends
Hardtail Frame Dual Down Legs |
|
$ 900.00 USD
Big Twin Frame. Has a unique Heim Joint axle block. Dual Down Tube. You choose Rake, stretch & tire size from stock to 200. Has Pan, Shovel and Evo Engine Mounts. Choose from 1 1/8'' to 1 1/4'' .120 wall tubing. Back bone tubing 1 1/2'' .188 wall. Has Softail forward control mounts. Comes with chain adjuster sprocket and 3/4'' axle. All frames are 100% tig welded with 100% american made steel. Shipping will be $135.00 us. You can also choose traditional axle block. Add $100.00 for curved backbone. Add $100.00 for Gooseneck. Add $50.00 for curved country bar. See pictures below.
|
|
Weld On Hardtail Section |
|
$ 400.00 USD
This is a weld on Hardtail Section for your stock shovelhead frame. Made of DOM 1 1/8'' tubing with seat section out of 1'' DOM tubing. All 100% tig welded. Has a unique Heim joint axle block. Comes with 3/4'' axle and chain tensioner. Cutting and welding required to your frame to mount this section. Please add $35.00 for shipping. You can also choose from a traditional axle block.
|
|
Springer Front End Narrow |
|
$ 750.00 USD
This Is a Narrow Springer Front End. It measures 5.5" in between the down legs and 8'' to the outside. Its Made from 1 1/4'' Made in the USA Chromoly tubing on the down legs. It has pressed in oil inpregnated bushings in the rockers. You will have to run a narrow glide sporster front wheel. This front end will except a front brake. It come 2'' under to 16'' over in 1'' increments. Comes Raw. Add $125.00 for powdercoating and $700.00 for chroming. Email for any questions. Shipping not included. After springer is built I will notify you with shipping cost to your address. Thanks.
|
|
Springer Front End Super Narrow |
|
$ 750.00 USD
This is a Super Narrow Springer Front End. It measures 3.5'' in between the down legs and 6'' to the outside. Its made from 1 1/4'' Made in USA Chromoly tubing on the down legs. It has pressed in oil inpregnated bushings in the rockers. You will have to run a spool front wheel on this springer. It comes in sizes from 2'' under stock to 16'' over stock in one inch increments. Comes Raw. Add $125.00 forPowder Coating and $700.00 for Chroming. Email for any questions. Shipping not included. After springer is built I will notify you with shipping cost to your address. Ball milling on the lower spring perch as shown is a $50.00 add on.
|
|
